LAARS NeoTherm NTV (Sizes 150–285 MBTU/h) - Service Manual - Manual (Page 83)

73 Service Manual NeoTherm 80 - NeoTherm 285
You will notice that the system did not ask you for a
password, so this is one of the values that can be
changed by anyone.
Entering a Time
The controller uses several different timing functions,
and you can change some of these. (In the example
shown in Fig. D5-5, we will use the screen for the Anti
Short-Cycle Time.
• The current setting appears in the upper right-hand
corner of the screen. In this example, this is 1 min-
ute.
• The numbers near the left edge of the screen show
the allowable range for this value. In this case, the
time can be set anywhere between 1 minute and 15
minutes.
In this example we will change the time delay to 5 min-
utes.
• Press the Left- and Right-Arrow buttons to move to
the box you want. In this case, we want to change
the middle box - the box for Minutes.
• Use the Up- and Down-Arrow buttons to change the
value in that box.
• You can change the numbers in the other boxes in
the same way.
• When the new setting is correct, press the round OK
button.
Fig. D5-5 - Changing a timing function
Using the Current User Interface - continued
D5
cont.