Microtel MicroWin 2000 - Manual (Page 27)

MicroWIN 2000 Manual
Version 1.0
22
On the Setup MicroWIN Entries form, either create a new entry or edit the entry that will be
used to connect remotely. While editing this entry, type in the telephone number of the dialer that
will be connected to.
Once finished typing in the telephone number, Save the changes.
Then, move back to the Realtime Data form. This time, when connecting to this entry’s dialer,
click on the button labeled Modem. Once clicked, MicroWIN 2000 will automatically connect
this entry to the first unused COM Port set up as a Modem.
If all has been properly setup, the picture in the upper right hand corner will read CALLING.
Once the dialer answers and they connect, this picture will read CONNECTED and after a little
handshaking, the dialer’s realtime status information will be displayed and will update every 1 to
3 seconds. See Appendix E: Dialer Channel Information, Page 95 for more information about
the Realtime Data.
To Disconnect from this dialer, click on the button labeled Disconnect. After a little
handshaking, the entry and dialer will be disconnected and the COM Port will go back to being
unused.
If a problem occurs while connecting or a dialer alarm condition is present once connected, an
alarm signal may be sounded. To silence this alarm, click on the Silence button above Alarm
Condition picture.
For more information about specific alarm conditions that may occur while connected, read
section Entry’s Current Alarm Condition, Page 50.