Microtel MicroWin 2000 - Manual (Page 30)

MicroWIN 2000 Manual
Version 1.0
Overview of Collecting Realtime Data
This section will briefly go over how to connect to an S1000 Dialer. It will give methods for how
to create a new entry, connect this entry to its dialer, and get data stored from this entry’s dialer.
This section assumes that the section Setting Up a Dialer to Talk to MicroWIN 2000, Page 6
has been read. This section also assumes that the sections Setting Up Dialer Entries, Page 9 and
Setting Up COM Ports, Page 13 have also been read. If any questions arise while reading this
section, please refer to these sections.
Adding a New Dialer to an Existing System
For the new dialer to be added to the system, determine if it will be connected up locally or
remotely and set it up accordingly.
Since this MicroWIN 2000 System is already setup to connect to other dialers, then the COM
Ports should already be pretty much setup from before. If the COM Ports are not currently setup,
see the section Setting Up COM Ports, Page 13 to setup the computer’s COM Ports.
From here, it is assumed that the MicroWIN 2000 System is ready to have a new entry added to it.
With MicroWIN 2000 running, move to the Setup MicroWIN Entries form. A list of the entries
that are currently in the system will be displayed.
Click the New button so that a new entry will be added to the system. Edit its parameters (Name,
Phone Number, etc.) and then Save it to the system.
25