Assemble the arches – New England Arbors VA84254 User Manual
Page 4
S T E P T H R E E
Lay out the two arch halves. Using the glue provided, run a small bead of glue along each internal tab of the arch ends as shown.
With the top side facing up, slip the bottom of each half together on a slight angle to join the two. Proceed to pinch in on the top
tabs to allow them to slide into the arch cavity. Once the tabs are inside, push the two halves completely together.
Assemble the Arches
1
2
www.newenglandarbors.com
1
3
4
The Devonshire Arbor
4
2
Using eight of the 3/4”screws provided, fasten the arches on all four sides through the pre-drilled holes.
Take the keystone base and top and connect them over the middle of the arch as shown. Make sure the pins in the base are
correctly inserted into the holes in the top. Push the two pieces together. No glue is required for this step.
3
4
5
Flip the arch over and slip each arch couplers into
the bottom of the arch. Push firmly until they snap
into place. No glue is required for this step.
Repeat steps one through five for the second arch.
6
5