New England Arbors VA84254 - Manual (Page 6)

S T E P F O U R
Slip the trim cap over the post and slide down about 12”. If you purchased the Trim Kit, slip the second trim cap as well as the
base moldings. No glue is required for this step.
Attach the Trim Pieces
1
www.newenglandarbors.com
6 The Devonshire Arbor
Included in the Trim Kit
Carry the side panels to the final location of the arbor and
Excavate four holes approx 36 in. (91.4 cm.) deep, 12 in. in diameter.
The spacing of the holes should be as per image aside.
Carefully move the side panels into the excavated holes.
Run a 2” - 3” long bead of glue on the ribbed flanged of the
arch couplers as shown.
S T E P F I V E
Install The Arbor
2
3
2
3
Into Earth with Concrete Footing
Arbors must be well secured to prevent tipping over from
wind load, etc.
1
36 in.
91.4 cm.
12 in.
30.5 cm.
(Measurements shown are inside to inside of posts)
49 in.
124.5 cm.
24 1/2 in.
62.2 cm.