CMS Products 674 - Manual (Page 27)

HotCup Operators’ Guide Initial Setup
November, 2007 21 6740001
4. Load the Optional Filter Paper:
a. Turn the fastener
1
/
4
turn counterclockwise and remove the filter paper cover.
b. Insert filter paper in the filter paper housing as shown.
c. Feed the paper out of the housing as shown by the arrows molded into the back wall of the filter paper
housing
d. Lift up the limit switch and feed the paper past it as shown. Release the limit switch.
e. Replace the cover. .
f. Refer to routing label on filter paper cover. Feed paper under paper guide shaft and over rounded edge
of stainless steel brackets as shown.
g. Lift and rotate the idler roller assembly up.
h. Route the paper under the brewer cylinder and the idler rollers.
i. Release the idler roller assembly, capturing the filter paper.