CMS Products 674 - Manual (Page 54)

Monetary Setup HotCup Operators’ Guide
6740001 48 November, 2007
ASSIGN CUP SIZES TO SELECTIONS
(Supervisor Mode Only)
You can load up to two different sizes of cups in your machine (See “Assign Cup Sizes to Selections”
on page 48). You may not always want a certain selection to use all of the cup sizes in your
machine. For example, espresso is normally served in regular cups, so you probably will not want it
to be available in large or jumbo cups.
a. Press , then press , until the display shows something like this: O.
ABCDEFGH . This display means that the smaller of the two cup sizes (0) is available for
selections (A-H).
b. Press to display all selections; press to clear all selections.
c. Press to display remaining selections ( 0 YZ2_ _ _ _ ). In this display, the “Y and Z”
represents the blended product, and the “2” represents the cup only selection.
NOTE:
If you have only one cup size in your machine, you will not see
the next display.
d. Press . The display shows something like this: 1. ABCDEFGH . This display means
that the larger of the two cup sizes (1) is available for all selections (A - H).
e. Press the appropriate letter to toggle the display on or off. A selection that doesn’t vend the
displayed size cup has its letter replaced by a dash (-).
f. Press to display all selections; press to clear all selections.
g. Press to display remaining selections (1 YZ2_ _ _ _ ).
In this display, the “Y and Z” represents the blended product, and the “2” represents the cup
only selection.
To vend a cup only, press 1, 2, 3 (large size) or 2, 3 (regular size).
h. Continue.