Slant/Fin Gas Hot Water - Manual (Page 21)

21
Additional Warranty Terms
All Boiler Models
Warranty extends only to boilers which have been properly
installed, operated and maintained in accordance with Slant/Fin
installation instructions and all applicable codes. Warranty applies
only if the boiler has remained at all times in the location at which
it was originally installed. Slant/Fin makes no express warranties
other than the warranties contained herein.
WARRANTY EXCLUDES:
All labor charges incurred by any person in connection with the
examination, removal, and repair of parts claimed to be defective
and the installation of replacement parts.
The part claimed to be defective shall be returned to Slant/Fin.
The cost of shipment to Slant/Fin is borne by the consumer.
Damage caused by water that contains excessive lime, calcium,
or other contaminants. Corrosion of cast iron heat exchanger
caused by low operating water temperature.
Boilers operated with combustion air that may be contaminated
by chemicals or improper fuel additives.
Boilers operated with water additives or water/system conditions
that may cause heat exchanger failure.
Boilers that have failed or malfunctioned due to improper or neg-
ligent operation, abuse, misuse, freezing, natural disaster, unau-
thorized alteration, improper installation or improper repair.
Improper burner adjustments, control settings or maintenance
procedures.
Boiler warranty is void if purchased on the Internet.
NOTE: Boilers are to be used in closed systems. Any application
that causes significant quantities of fresh make up water to enter
the system is not permitted. Such applications can be met with a
heat exchanger that will maintain the boilers in a closed system.
AFTER FIRST YEAR, WARRANTY EXCLUDES:
All boiler components other than a cast-iron or cast-aluminum
heat exchanger, such as, sheet metal base, jacket, insulation,
combustion chamber, tankless heater exhaust and air inlet pip-
ing, burner enclosure, mixing elbow, gas and air orifice, blower
assembly, air filter and electrical and mechanical components fur-
nished to Slant/Fin by other manufacturers, such as pumps,
relays, controls, gauges, etc.
PROCEDURE FOR WARRANTY SERVICE:
For warranty service, provide the person who installed your
Slant/Fin boiler with the following information: boiler model num-
ber and serial number (from the boiler rating plate) and the date
of installation. That person will notify the Slant/Fin wholesaler
from whom the boiler was purchased.
Part(s) claimed to be defective must be returned through trade
channels and replacement part(s) will, if warranty conditions are
met, be provided by Slant/Fin through the wholesaler.
If there are any questions about the coverage of this warranty,
please contact Slant/Fin at the address shown below.
LIMITATIONS ON IMPLIED WARRANTIES AND DAMAGES:
Slant/Fin assumes no liability for damages or unsatisfactory
performance of any kind which is a result of improper installation.
Slant/Fin's sole obligation in the event of a breach of any implied
warranty (including, but not limited to, implied warranties of mer-
chantability and fitness for a particular purpose) is limited to
repair or replacement, and all such warranties are limited in dura-
tion to the period of time after the date of original installation as
stated above.
This warranty does not cover claims for incidental or consequen-
tial damages resulting from a breach of any express or implied
warranty or any other reason.
Some states do not allow limitations on how long an implied war-
ranty lasts or the exclusion or limitation of incidental or conse-
quential damages. So the above limitation or exclusion may not
apply to you.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS
AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY
FROM STATE TO STATE.
Technical Service Department
Slant/Fin Corporation, 100 Forest Drive, Greenvale, N.Y. 11548 • (516) 484-2600
[email protected]
Effective October 2010