Slant/Fin CHS-399 - Manual (Page 74)

Slant Fin Corp. │ Installation and Operation Instructions CHS Series
74
Table 15-3 Hold and Lockout Codes
Code Description Note
233 Invalid IAS closed response setting Lockout
234 Invalid Outlet high limit enable setting Lockout
235 Invalid Outlet connector type setting Lockout
236 Invalid Inlet connector type setting Lockout
237 Invalid DHW connector type setting Lockout
238 Invalid Stack connector type setting Lockout
239 Invalid Header connector type setting Lockout
240 Invalid Outdoor connector type setting Lockout
241 Exchanger sensor not allowed with stack connector setting Lockout
242 Invalid DHW auto detect configuration Lockout
243 Invalid UV with spark interference not compatible with Igniter on throughout
PFEP Lockout
244 Internal fault: Safety relay test invalid state Lockout
245 Invalid Outlet connector type setting for T-rise Lockout
246 4-20mA cannot be used for both modulation and setpoint control Lockout
247 Invalid ILK bounce detection enable Lockout
248 Invalid forced recycle interval Lockout
249 STAT cannot be demand source when Remote Stat is enabled Lockout
250 Invalid Fan speed error response Lockout
251 Lead drop-stage on error setting does not match drop method configuration Lockout
252 Invalid Line frequency setting Lockout
253 Lead Lag modulation sensor not valid with setpoint source Lockout
254 Lead Lag modulation sensor not valid with local setpoint source Lockout
255 Lead Lag modulation sensor not valid with local modulation source Lockout
256 Selected Controller interaction enable setting is not allowed Lockout
257 Controller interaction enable does not match neighbor stack fault setting Lockout
258 Controller ID must be non-zero if controller interaction is enabled Lockout
259 Modulation output must be fan if controller interaction is enabled Lockout
260 Asymmetrical paired (no flap) is set but flap switch input is energized Lockout
261 Neighbor burner control blower fault detected Lockout
262 Blower fault detected during flap test Lockout
263 Invalid DHW demand temperature setting Lockout
264 Invalid preferred outlet high limit setting Lockout
265 Invalid preferred lightoff rate setting Lockout
266 Invalid preferred stack limit rate setting Lockout
Table 15-4 Alert Codes
Code Description
0 None (No alert)