Slant/Fin CHS-399 - Manual (Page 14)

CHS Series CHS 300-399 Common Venting
│ Slant Fin Corp.
14
12. Exhaust Support – Secure the Exhaust Manifold
in place by installing the tops of the Exhaust Supports
using 1/4" x 1" Machined Screws.
12
Top of Exhaust Support
& 1/4" x 1” Machined
Screws
10. Branch – Insert the 6” x 4” Branch fittings into the
4” Elbows installed in Step 9, starting with the boiler on
the left (start with the boiler on the right if the Exhaust
Gas is being piped to the left). Use Centrocerin lubricant
and a Connector Ring at each connection.
NOTE: Exhaust gas branches are piped to the right; therefore
Branches are required to be cut to an overall length of 33”
Elbow
4” Connector
Ring
10
Branch
11. Horizontal Drain – Install the Horizontal
Drain onto the left side (male end) of the
Exhaust Manifold (if Exhaust Gas is being
piped to the left, install Horizontal Drain on the
right side of the Manifold). Use Centrocerin
lubricant and a Connector Ring at each
connection.
11
Branch
6” Connector
Ring
Drain
Fitting
Horizontal
Drain