TeeJet Legacy 6000 RMS_EXT User Guide - Manual (Page 35)

RMS-EXT for the Legacy 6000
Software Version 2.00
Chapter 3 - Real-time Setup 3-3
RMS-EXT Real-Time Setup
Real-time Setup Steps
Step Description
Job: When you press the ARM Bull’s-eye button, the Job page appears. Select
or create the desired job. There must be a PC Card in the console to store a
job. Press the forward key to continue to the ARM Launcher page.
Report Setup: If creating an application report, run Report Setup to enter
Agency, Operator, and Driver information. The Agency and Personnel profiles
contain this information.
ARM Setup: Name the Map file here if points are being mapped during product
application. Select Base Map files here as well. There are three additional
parameters: collection interval, alarm, and Alarm Range.
Product Setup: Make tank assignments here.
When you have completed the above steps and have properly setup the con-
sole, start real-time operation by pressing the ARM Bull’s-eye. Review “Chap-
ter 4 - Real-time Operation”.
Table 3-1: Start Product Application Process