TeeJet Legacy 6000 RMS_EXT User Guide - Manual (Page 44)

4-2 Chapter 4 - Real-time Operation
Product Application
RMS-EXT for the Legacy 6000
Software Version 2.00
Product Application
When the Real-time Setup process is complete (see “Chapter 3 - Real-time Setup), product appli-
cation can begin. This is accomplished by pressing the ARM Bull’s-eye located on the ARM Main
Launcher page (Figure 4-1).
When the ARM Bull’s-eye soft-key is pressed, the RMS-EXT software loads all setup information.
This loading process may take a few seconds to complete. When the loading process is complete,
the Rates page (Figure 4-2) appears.
Real-time Pages
There are two real-time page types: the Rates page (Figure 4-2) and the Map page (Figure 4-6).
Each page has the same layout: a left column of soft-keys, a center column that displays rate or
map information, and a right column of soft-keys.
The left column is reserved for product control soft-keys. There is a soft-key for each product used
in the current product application. If there is only one product, there is no soft-key in the left col-
umn. E.G. if a Legacy 6000 is connected to an external rate controller configured as a two product
system, there are two product control soft-keys. If there are more than four products being applied,
the left column becomes scroll-able to access the additional product control soft-keys. The left col-
umn is the same for the Rates page and the Map page. This allows the control of a product while
viewing the application map. A product control soft-key contains the product name and the current
rate being applied.
The right column soft-keys vary, depending on which page is currently being viewed. When view-
ing the map page, the right column contains all of the mapping, guidance, and general viewing
Figure 4-1: The ARM Launcher Page
ARM Bull’s-eye
soft-key