Settings – Toa C-RM700 User Manual
Page 25
25
OPERATION MODE *
(
p. 29
)
Designates this unit as a master, or slave.
SWITCHER *
(
p. 29
)
Determines the type of switcher to be connected to this unit.
MANUAL SPEED
(
p. 32
)
Sets the combination camera's maximum rotation speed in manual
operation.
AUTO KEY
(
p. 32
)
Sets the automatic operation to ON or OFF when type B is
connected to this unit.
TIME ADJUSTMENT
(
p. 33
)
Sets whether or not to adjust the combination camera's clock.
ALARM HOLD
(
p. 41
)
Sets the monitor display to be switched when an alarm signal is
received.
PROTOCOL
(
p. 30
)
Sets the camera control protocol (RS-485 communication).
FUNCTION
(
p. 42
)
Displays the corresponding preset camera image (camera number and
position number) on the monitor by simply pressing a Function key.
ABBREVIATION
(
p. 44
)
Displays the corresponding preset camera image (camera number and
position number) on the monitor when the abbreviated number (entered
with the numeric keypad) is entered, followed by the SET key.
CAMERA MENU
(
p. 46
)
Calls up the camera's built-in menu screen, permitting various
Combination camera settings, such as present position.
I/O SELECTION
(
p. 46
)
Selects when outputting the operation commands from an RS-
232C port to a master remote controller.
AUTO RETURN
(
p. 33
)
Sets the function to automatically return the camera to a specified
(Home) position after operation completion.
HOME POS
(
p. 34
)
Sets the Combination camera's standby status when it is not
controlled at all.
BUZZER *
(
p. 36
)
Sets whether or not to sound a buzzer when an alarm is engaged.
CAMERA ALARM
(
p. 38
)
Sets to "ON" when using the Combination camera's alarm contact input.
PRESET CAM ALARM
(
p. 39
)
Sets the position number in which the Combination camera will
automatically face when an alarm contact close information is
received from the camera.(Only valid when "1. ON" has been
selected in the "Camera alarm" setting.)
I/O SPEED *
(
p. 35
)
Sets the transfer rate of each control terminal.
INITIAL SCREEN
(
p. 36
)
Sets the screen to be displayed on the monitor immediately after
the power is switched ON.
INITIAL CHANNEL
(
p. 37
)
Sets the channel (camera number) to be displayed first when the
power is switched ON.
SENSOR ALARM
(
p. 38
)
Set to "ON" when using the Sensor Alarm function.
ALARM SIGNAL
(
p. 40
)
Sets the type of alarm continued action.
PASSWORD
(
p. 47
)
Sets the password required to open the menu.
ALARM TIME
(
p. 40
)
Sets the time interval from alarm signal reception to reset.
ALARM FUNCTION
(
p. 41
)
Sets the monitor display method when an alarm signal is
received.(Only valid when "1. EDGE" has been selected in the
"Alarm signal" setting.)
TOUR SEQ
(
p. 45
)
Sequentially displays two or more camera outputs on the full screen
in order of reproduction (1-128) at preset time interval (seconds).
Note: Only the setting items marked with "*" can be performed when "2. SLAVE" has been selected in the
"Operation mode" setting. In this event, other items are not displayed on the menu screen.
CAMERA CHECK
(
p. 31
)
Checks the Combination camera connected to the camera control
terminal for 30 seconds.
7. SETTINGS
7.1. Setting Items and Their Descriptions