Toa C-RM700 - Manual (Page 33)

33
7.4.7. Time adjustment (Protocol: Type B only)
The Combination camera's built-in clock can be set when the alarm output/control terminal (Pin 23) is closed
with the Ground. The cameras of which built-in clock can be adjusted are C-CC514, C-CC564, C-CC574, C-
CC764, and C-CC774. (Refer to
p. 51 , "Alarm Output/Control Input Terminal Connections."
1. Press the Menu key for 3 seconds or more to display the menu screen.
2. Tilt the joystick up or down to select "TIME ADJUSTMENT," and confirm it with the SET key.
The setting contents will appear on Line 2.
3. Tilt the joystick left or right to select one of the following setting contents and confirm it with the SET key.
[Setting contents]
T I M E A D J U S T M E N T
1 . O F F 1
1. OFF Disables time adjustment.
2. 1:00 - 24. 23:00 Sets the time to receive contact input for the clock synchronization. Sends a
corresponding command relative to that time to the cameras.
Confirming this setting displays the screen for setting the time interval before
Automatic Reset occurs following camera operation.
Tilt the joystick left or right to select the reset interval: "10 SEC," "15 SEC," "20 SEC,"
"30 SEC," "1 MIN," "2 MIN," "3 MIN," "4 MIN" and "5 MIN." The selected time is
confirmed with the SET key.
Note: "SEC" of the reset interval stands for seconds, and "MIN" for minutes.
Disables the Automatic Reset function.
7.4.8. Automatic reset
Enables the function that automatically resets the camera to a fixed position (home position) if the camera is
not operated for a preset time interval following camera operation.
1. Press the Menu key for 3 seconds or more to display the menu screen.
2. Tilt the joystick up or down to select "AUTO RETURN," and confirm it with the SET key.
The setting will appear on Line 2.
3. Tilt the joystick left or right to select one of the following setting contents and confirm it with the SET key.
[Setting contents]
A U T O R E T U R N
1 . O N 1
A U T O R E T U R N
1 . O N 1 0 S E C 1
1.ON
2. OFF
Note: This selection is set to "2. OFF" by the factory.
Note: When using the Timer Program and Alarm Action functions at the Combination Cameras, operations of
the Combination Camera itself takes precedence. So use the Combination Camera's Automatic Reset
function. This unit's Automatic Reset function may not be activated.