Toa C-RM700 - Manual (Page 9)

9
16-segment split-screen key *1
Displays camera images in the 16-segment split
screen format on the monitor.
10-segment split-screen key *1
Displays camera images in the 10-segment split
screen format on the monitor. Each depression
of this key during the 10-segment split screen
display switches the screen between Group 1
image display and Group 2 image display.
9-segment split-screen key *1
Displays camera images in the 9-segment split
screen format on the monitor. Each depression of
this key during the 9-segment split screen display
switches the screen between Group 1 image
display and Group 2 image display.
4-segment split-screen key *1
Displays camera images in the 4-segment split
screen format. Each depression of this key during
the 4-segment split screen display cycles through
screens showing images of Groups 1 to 4.
Sequential 4-segment split-screen key *1
Sequentially cycles through all connected
camera outputs of up to 4 groups of cameras at
a preset time interval, and displays camera
images in the 4-segment split screen format on
the monitor. (Sequencing interval is set at the
Switcher.)
Group selector key *1
Switches on-screen camera groups during 4-, 9-
or 10-segment split-screen display on the
monitor.
Sequence key *1
Sequences all connected camera outputs to the
full screen at the specified time interval.
(Sequencing interval is set at the Switcher.)
Clear key [C]
Used to correct entry errors through numeric
keypad. Also, turns off the buzzer when sounded
by an activated alarm.
Numeric keypad [0 - 9]
Used to enter the camera number, position
number, abbreviated number, etc.
SET key
Used in conjunction with the numeric keypad to
program the camera number or position number.
Also, if pressed after entering the set abbreviated
number with the numeric key, the full-screen
camera image corresponding to that number can
be displayed on the monitor.
Camera key
Displays the full-screen camera image
corresponding to the specified camera number.
This key does not function even if pressed
without entering the camera number.
Position key
Orients the Combination camera toward the set
direction. The Position key can only be used
when the Control key is lighting. Pressing the
Position key without designating the position
number orients the camera toward the direction
programmed under Position No. 1 (Home
position).
Control key
Used to designate the camera to be manually
controlled during a multi-screen display. This key
cannot be used during a full-screen or sequential
display. Also, nothing is operated even if this key
is pressed without designating the channel
number. The key lights when the camera is
controllable.
Freeze screen key *1
Freezes camera images. However, sequential
displays cannot be made still. The key flashes
when there is a freeze image on the screen.
Alarm reset key
Resets the system's Alarm mode. The key
flashes during Alarm operation.
Alarm hold key
Places activated Alarm inputs on hold. The key
flashes during Alarm Hold.
CH call key *1
Displays the camera number on the monitor for a
preset period of time.
This key is convenient for finding the camera
number when no indication or only the camera
name is displayed.
Menu key
When performing each setting, hold down the key
for 3 seconds or more to display the menu on the
LCD screen. Pressing the key again will close the
setting screen and the display will disappear.
Wiper key *2
Remotely controls the outdoor-use Combination
camera's wiper. This key can only be used while
the Control key is lighting.
Auxiliary 1 and Auxiliary 2 keys *2
Control (close or open) the Combination
camera's Auxiliary Contact Outputs.
The key lights when auxiliary contact is closed,
and goes out when open. This key can only be
used when the Control key is lighting.