Toa C-RM700 - Manual (Page 45)

45
7.4.23. Tour sequence
The Tour Sequence function switches multiple camera outputs in sequence at a set time interval (seconds).
Merely pressing the Sequence key permits up to 16 camera outputs to be displayed on the full screen in the
order of their set playback number.
The camera number, position number and viewing time can be set for individual playback numbers.
1. Press the Menu key for 3 seconds or more to display the
menu screen.
2. Tilt the joystick up or down to select "TOUR SEQ," and
confirm the selection with the SET key.
This unit will wait for the entry of "YES" (to use the function) or "NO" (to not use the function).
3. Tilt the joystick to the left or right to select either "YES" or
"NO," and confirm the entry with the SET key.
The setting is displayed on Line 2 if "YES" is selected, and
the unit switched to playback number entry waiting mode.
Note that when the camera number or the position number
is not programmed in advance, the "***" indication is
displayed in place of the number.
4. Enter the playback number using the numeric keypad or by
tilting the joystick to the left or right, and confirm the
entered number with the SET key.
Enter a number from 1 to 128. The flashing cursor moves
to the camera number.
5. Enter the camera number with the numeric keypad, and
confirm the number with the SET key.
Enter a number from 1 to 16.
The flashing cursor moves to the position number.
6. Enter the position number with the numeric keypad, and
confirm the number with the SET key.
Enter a number from 1 to 255.
Note: Entering "0" will switch the screen to full screen
display, and does not execute position playback.
The flashing cursor moves to the rightmost viewing interval
selection indication on Line 2.
7. Tilt the joystick to the left or right to select the viewing
interval: "3SEC," "10SEC," "15SEC," "20SEC," "30SEC," or
"1MIN," and confirm the interval selection with the SET key.
Note: (SEC: seconds, MIN: minutes)
8. Repeat Steps 4- 7 to continue setting the playback
numbers.
Press the Clear key to return to the setting item display.
[Deleting Settings]
After pressing the Alarm reset key, press the SET key.
4
3
5
6
7
T O U R S E Q Y E S Y
SET
T O U R S E Q 1
C P T 1 0 S E C
1
1 SET
(Example)
T O U R S E Q 1
C P T 1 0 S E C
1 2 SET
(Example)
T O U R S E Q 1
C 1 2 P T 1 0 S E C
2 0 0 SET
(Example)
T O U R S E Q 1
C 1 2 P 2 0 0 T 2 0 S E C C
SET
Playback No.
T O U R S E Q N O N
(Set by the factory)