VACUUBRAND CVC 3000 E - Manual (Page 15)

page 15 of 75
to be sure that the power source and the equipment
match in voltage, phase, and frequency.
• When working with residues, aggressive or condens-
able media, install a gas washing bottle if necessary.
Using a wall power supply, assemble and lock the suit-
able power plug (included in shipment) to the power sup-
ply prior to use.
The controller is equipped with a short-circuit-proof, wide-
range power supply with an integrated overload protec-
tion.
Avoid high heat supply (e.g., due to hot process gases).
Position the controller CVC 3000 E and its vacuum line in
such a way that condensate cannot flow towards the pres-
sure transducer.
In case connect inert gas at the venting connection.
Allow the equipment to equilibrate to ambient temperature
if you bring it from cold environment into a room prior to
operation. Notice if there is water condensation on cold
surfaces.
Comply with all applicable and relevant safety require-
ments (regulations and guidelines). Implement the re-
quired actions and adopt suitable safety measures.
Ambient conditions
➨
Do not reach for this product if it has fallen into liquid.
There is a risk of deadly electrical shock. Unplug the
system immediately.
+
Do not use this product in an area where it can fall or
be pulled into water or other liquids.
• Adopt suitable measures in case of differences from
recommended conditions, e.g., using the equipment
NOTICE