VACUUBRAND CVC 3000 E - Manual (Page 24)

page 24 of 75
Use and operation
The CVC 3000 E VACUUBRAND controller with internal pressure trans-
ducer and integrated venting valve controls the solenoid operated in-line
valve, VACUUBRAND diaphragm pumps (via VMS module A, see “Ac-
cessories”, pg. 64) , and optional coolant and venting valves.
When switching on the controller CVC 3000 E for the very first time, a
menu to select the language of the controller menu is displayed. Select
the desired language (e.g., ”English”) by turning the selection knob and
press to confirm. Then select the pressure unit (”mbar”, ”Torr” or ”hPa”)
in the same way.
It is possible to access the language selection menu at any time
by switching on the controller while keeping the selection knob
pressed.
After switching on the device, the version number of the software is
displayed, followed by the preselected function and the pressure reading.
Connected components (e.g., venting valve, level sensor, external pres-
sure transducer 3000 series) are automatically identified. Identical com-
ponents must be configured beforehand; information upon request.
Do not use more than one controller within the same VACUU•BUS
system. Several controllers in the same VACUU•BUS system will inter-
fere with each other and result in error messages of the connected com-
ponents (pumps, valves).
Assembling the country-specific power plug
+
The wall power supply is delivered with
power plugs for Europe, UK, US and Aus-
tralia.
+
Press the locking key at the wall power sup-
ply to remove and to replace the power plug
with your country-specific plug.
+
Assemble the suitable power plug to the
power supply and lock.