VACUUBRAND CVC 3000 E User Manual
Page 65
Use VACUU•BUS Y-adapters and extension cables to connect further
components. When connecting an external pressure transducer, it is
used automatically. Further information on how to use several sensors
simultaneously is available on request.
Conversion of VACUUBRAND valves with DIN plug to
VACUUBRAND valves with VACUU•BUS plug:
VACUUBRAND-valve with DIN
plug
Conversion kit valve cable with
VACUU•BUS plug
In-line valve VV 6, 24V= (674090)
In-line valve VV 6C, 24V= (674091)
in-line valve VV 15, 24 V= (674110)
in-line valve VV 15C; 24V= (674115)
612556 (conversion to in-line valve)
612566 (conversion to venting valve)
Coolant valve VKW, 24 V= (676013)
612567
Venting valve VBM, 24 V= (666817)
612554
In-line valve water jet pump (610623)
612556
➨
To control a
VACUUBRAND water jet pump (695000) with solenoid
operated valve with diode plug with a CVC 3000 controller instead of
with a controller CVC 2 / CVC 2
II
, the valve cable has to be replaced
(see table). After the replacement of the cable the water valve will be
switched like an in-line valve.
Level sensor.................................................................................................699908
(control of liquid level in catchpots)
VACUU•BUS Digital-I/O-Module .................................................................636228
(e.g., fault indicator / remote module)
VACUU•BUS Analog-I/O-Module ................................................................636229
(for analog input and output of vacuum and motor speed)
VMS-B module 100-230V 50/60Hz (with connection cable) ........................676030
PC-Software VACUU•CONTROL .................................................................692920