Winco DSE7300 Series - Manual (Page 14)

DSE Model 7000 Series Control and Instrumentation System Operators Manual
14 Part No. 057-074 7000 Series OPERATING MANUAL ISSUE 5 15/10/2009 ADM
3.10.2 USB CONNECTION
The USB port is provided to give a simple means of connection between a PC and the DSE7000 series controller.
Using the DSE Configuration Suite Software, the operator is then able to control the module, starting or stopping the
generator, selecting operating modes, etc.
Additionally, the various operating parameters (such as output volts, oil pressure, etc.) of the remote generator are
available to be viewed or changed.
To connect a DSE7000 series module to a PC by USB, the following items are required:
•
DSE7200 or DSE73000 series module
•
DSE 7000 series configuration software
(Supplied on configuration suite software CD or available from
www.deepseaplc.com).
•
USB cable Type A to Type B.
(This is the same cable as often used between a PC and a USB printer)
DSE can supply this cable if required :
PC Configuration interface lead (USB type A – type B) DSE Part No 016-125
NOTE:- The DC supply must be connected to the module for configuration by PC.
NOTE:- Refer to DSE7000 series Configuration Suite Manual for further details on configuring,
monitoring and control.