XMART Optima-RACK 10K - Manual (Page 37)

USER MANUAL - OPTIMA UPS 6K/ 10K (ENGLISH)
______________________________________________________________________________________________________________________
20140805 Tower-Rack 6K-10K ISOTX - 37
12.- ERROR CODES, ALARMS & TROUBLESHOOTING
ERROR / FAILURE CODES ON LCD
When a failure or alarm is detected by the UPS, an alarm or error code is presented in front panel LCD. This code or symbol
will allow to identify the problem. In case of failure or alarm, service center must revise the problem.
ERROR CODE ERROR DESCRIPTION ICON BEEP ALARM
1 Bus failure
Continous
Beep
2 Hi BUS Voltage
3 Low BUS Voltage
4 Bus Unbalanced
5 BUS shortcircuit
11 Inverter soft start failure
12 Inverter HI voltage
13 Inverter LOW voltage.
14 Inverter output short-circuit SHORT
1A Negative Voltage failure
21 Battery SCR Short-Circuit
24 Inverter Relay Short-Circuit
28 Battery connection problem BATT. FAULT
35 Parallel Communication problem
36 UPS Output Short-Circuit
41 HIGH Temperature.
42 CPU communication problem
43 UPS Output Overload OVER LOAD
ALARM
CODES ON LCD
ALARM DESCRIPTION BEEP/Sec
LOW BATT. Low Battery 1 beep / s
OVER LOAD
UPS Overload: High power consumption in Watts at
UPS output
2 beep / s
BATT. FAULT Batteries disconnected 1 beep / s
EP
EPO (emergency power off) activated 1 beep / s
High Temperature 1 beep / s
Battery Charger Failure 1 beep / s
Input Fuse Activated 1 beep / s
Repetitive Overloads Detected (3 in 30 minutes) 1 beep / s
3F
Parallel Failure (**) 1 beep / s
FLASHING ICON
Battery Overload 1 beep / s
WARNING:
** Some alarms can block UPS avoiding normal operation of UPS until they are reset. Technician must
revise original error cause has been solved and then alarm must be reset by simultaneous selection of UP and DOWN
keys in front panel meanwhile UPS is in BYPASS mode (connected to AC source previous to select ON command).