Stationary mode, Power take off operation — if equipped, Chassis cab only) – Ram Trucks 2015 Chassis Cab Commercial - Owner Manual User Manual

Page 350

Advertising
background image

cause damage to the transmission. The torque con-

verter will refill within five seconds after starting the

engine.

POWER TAKE OFF OPERATION — IF EQUIPPED
(CHASSIS CAB ONLY)

This vehicle when equipped with PTO Prep and the

AS66RC automatic six-speed, will allow for an aftermar-

ket upfit with a transmission driven PTO (power take

off). The customer will have the ability to operate the

PTO in either a “stationary” or “mobile” mode. The

vehicles will be factory set to the “stationary” mode. To

select ’mobile mode’ You will need to enter the commer-

cial vehicle menu on the EVIC/DID screen and select

mobile PTO mode. Details of the PTO selection modes

and further PTO information is available at the Ram

Truck Bodybuilders web site. www.rambodybuilder.com

AS66RC Six-Speed Automatic Transmission Only

The PTO drive gear (part of the AS66RC) operates at

torque converter turbine speed. The turbine speed will be

less than engine speed when the torque converter clutch

is not engaged and will be same as engine speed when

the torque converter clutch is engaged.

Stationary Mode

To operate the PTO in this mode the vehicle must meet

the following conditions:

• Be in PARK position (vehicles equipped with auto-

matic transmission.)

• PTO switch has been activated.
• Parking brake applied (vehicles equipped with

manual transmission).

• Brake pedal must not be applied.

348 STARTING AND OPERATING

Advertising