Ram Trucks 2015 Chassis Cab Commercial - Owner Manual User Manual

Page 459

Advertising
background image

• With electronic shift transfer case, press and hold the

transfer case NEUTRAL (N) button until the NEU-

TRAL (N) indicator light turns off. After the NEU-

TRAL (N) indicator light turns off, release the NEU-

TRAL (N) button. After the NEUTRAL (N) button

has been released, the transfer case will shift to the

position indicated by the selector switch.

NOTE:

When shifting the transfer case out of NEUTRAL

(N), the engine should remain OFF to avoid gear clash.
6. Shift automatic transmission into PARK.
7. Release the brake pedal (and clutch pedal on a manual

transmission).

8. Disconnect vehicle from the tow vehicle.
9. Start the engine.
10. Press and hold the brake pedal.
11. Release the parking brake.

12. Shift the transmission into gear, release the brake

pedal (and clutch pedal on manual transmissions),

and check that the vehicle operates normally.

NOTE:

With electronic shift transfer case:

• Steps 3 through 5 are requirements that must be met

before pressing the NEUTRAL (N) button, and must

continue to be met until the shift has been completed.

If any of these requirements are not met before press-

ing the NEUTRAL (N) button or are no longer met

during the shift, the NEUTRAL (N) indicator light will

flash continuously until all requirements are met or

until the NEUTRAL (N) button is released.

• The ignition switch must be in the ON/RUN position

for a shift to take place and for the position indicator

lights to be operable. If the ignition switch is not in the

ON/RUN position, the shift will not take place and no

position indicator lights will be on or flashing.

• A flashing NEUTRAL (N) position indicator light

indicates that shift requirements have not been met.

5

STARTING AND OPERATING 457

Advertising