Carrier 30HK - Manual (Page 13)

Tube information:
in. (mm)
Tube sheet hole diameter...... .... 0.631 (16.03)
Tube OD............................... .... 0.625 (15.87)
Tube ID after rolling............. .... 0.581 (14.76 to
(includes expansion due to 14.94)
to clearance) 0.588
BOLT TIGHTENING SEQUENCE (Fig. 11)
The following is a recommended bolt tightening
sequence:
Step 1 — Tighten moderately (without torquing)
all the flange bolts in sequence shown.
Step 2 — Repeat Step 1, tightening bolts to speci­
fied torque.
NOTE: Tubes next to gasket webs must be flush
with tube sheet (both ends).
Tightening Cooler Head Bolts
GASKET PREPARATION
When reassembling, use new gaskets. Com­
pressed asbestos neoprene gaskets. Carrier Material
Specification ZAOO-24, are to be momentarily
dipped in compressor break-in oil prior to assembly.
Do nut soak gaskets in oil as gasket deterioration
results. Use dipped gaskets within 30 minutes to
prevent deterioration.
BOLT TORQUES
Apply the following torques during bolt tighten­
ing sequence described below:
1/2-in. diameter flange bolts.............. 70 - 90 lb ft
Fig. 11 — Tightening Sequence,
Cooler Head Bolts
Tuet SHEET
Fig. 10 — Elliott Tube Plug
13 1090