Sears 17891 - Manual (Page 15)

Fig. 1
Fig. 2
fhis michln« is fitted with s zipag presser
feet for general sewing purpoits. The
following idditlonat presser feet are found In
the aooesaorv ‘.
1.
2 .
3.
4.
5.
Straight stitch foot
Satin stitch foot
Buttonhole foot
BuilMn buttonhole guide foot
Zipper foot
CHANÜIiiQ l»lliSSEII FEET
Make sure needle is in the up position. Raise
presser foot lever.
Snef-on preiser fee
1, Raise foot relesie levtr lo remove me
foot. IFig. 1)
2. Place desired foot on the needle plate
aligning needle holes. Lower the presser
foot levw^ so that foot holder snaps on the
(Fig. 2)
One-piece presser feet (Fig. 31
1, Loosen presser foot thumb screw and
ramova the lopt holder.
2. Insert desired foot from the left. Lower
the presser foot iew»r and tighten the
screw using the large screw driver to
make certain the foot Is secure.
For machines with presser foct lock (Fig. 4).
To change presser feet, simply drop Pres^r
Foot Lock and slip loot away from the
Presser Bar. Raise Presser Foot Lever beyond
the normal up position and place new fool on
presser bar. To lock foot securely, raise
presser foot lock as high as possible.
|££ËD COVER PLATE
There are a few times when you want to
control the feeding of the fabric yourself.
Raise needle to its highest position and raise
presser foot. Place feed cover plate over
needle plate aligning two pins of feed cover
plate with holes of needle ptate. You may
then determine the movement of the fabric
"'yourself....... ...................... ■ ." ■
14