Sitflnci up youit machini – Sears 17891 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SiTflNCI UP YOUIt MACHINi
1. Initall your Kanmori sewing machine in a
Kanmort cabinet or
cm »*
or eat the
machine on a sturdy flat surface.
2. Your Kertmort sewing rnachine has bean
thoroughly oited at the factory. 8tt sure to
wipe elf ^ needie piste arse ami bad
ptete carefutiy before sewing a prment.
It HI wise to practice on a scrap of fabric
no any suiplus oil is absorbed.
FOOT CONTROt
Make tsjre power/light switch is off. Plug
foot control plug into machlns r^aptscte.
Then connect cord into any 110^120 volt
A. C. wall outlat.
Foot control
Powar/llght
Speed range
switch
twitch
POWER/LIOHT SWITCH
Your machlrie wtK not operete unless ths
power/light switch Is turned on, Turning on
the pcwver sutomstically illuminates the
stitching ares. If you're interruphsd or stop
sewing and leave the machine, turn off the
power/light switch.
SPEED RANGE SWITCH
Your machine has two rangas of speed-a
low range for slower, Intricahs work and a
high one for faster, generel work. On the low
Sitting
the machine will sew no faster than
approximately ona-haif the spaed of the high
one, even whan the foot control is fully
depressed.