SINGER 95-100 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
8
To Wind the Bobbin
(See Fig.10)
Fasten the bobbin winder to the table with Its driving pulley
In front of the machine belt, so that the pulley will drop away
from the belt when sufficient thread has been wound upon the bob
bin.
£/г557
Fig.10. Winding the Bobbin
Place the bobbin on the-bobbin winder spindle and push It on
as far as It will go.
Pass the thread down through the thread guide (1) in the ten
sion bracket, around the back of, and between,the tension discs
(2). Then wind the end of the thread around the bobbin a few
times, push the bobbin winder pulley over against the machine
belt and start the machine.
When sufficient thread has been wound upon the bobbin, the
bobbin winder will stop automatically.
If the thread does not wind evenly on the bobbin, loosen the
screw (A) In the tension bracket and move the bracket to the
right or left as may be required, then tighten the screw.
The amount of thread wound on the bobbin Is regulated by the
screw (B). To wind more thread on the bobbin, turn the screw (B)
Inwardly. To wind less thread on the bobbin, turn this screw
outwardly.
Bobbins can be wound while the machine Is stitching.