SINGER 95-100 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
17
To Time the Sewing Hook
Remove presser foot, slide plate, throat plate and bobbin
case. Take out the two screws (E2,Flg.20) and remove feed dog.
Fig.21. Needle and Sewing Hook Correctly Timed
To determine that the hook Is correctly timed, place a new
needle In the machine, then turn the balance v^eel over toward
you until the LOWER TIMING MA.RK on the needle bar Is centered
with the lower end of the needle bar bushing as shown at (Q,Flg.
21)vWhen the needle bar Is on Its upward stroke. With the
needle bar In this position, the point of the hook should be at
the center of the needle as shown at (R,Flg.21). The Inset In
circle at the left of Fig.21 plainly shows this position of the
hook point relative to the needle.