Selecting a pattern group, Adjusting width of the design, Adjusting stitch placement – SINGER 9614 User Manual
Page 45
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1
6-7
SELECTING A PATTERN
GROUP
Before moving pattern group selector, make
sure needle is above fabric.
When you rotate the pattern group selector,
one of 8 different groups of stitch pattern is
available to you.
Slide stitch width selector to
0
,
then rotate the
pattern group selector as required, until the
number of the desired group of two stitches is
positioned under the • symbol above the
selector.
0
ADJUSTING WIDTH OF THE DESIGN
Before moving stitch width selector, always
raise needle above fabric.
To produce a stitch pattern, the stitch width
selector must be moved from
0
toward the
right. The further you move the selector lever
toward the right, the wider your stitch will be.
ADJUSTING STITCH PLACEMENT
Before moving needle position selector, make
sure needle is above fabric.
All stitch patterns can be sewn in either left
^ , centre , or right w , needle position.
Selector setting centre u is used most often.
A !m left or M right setting is used to place
narrow stitch patterns to the left or right of the
centre in decorative work.
43