SINGER 14U236B - Manual (Page 13)

(2) Thread the left looper (yellow path)
Remove cylinder cover and thread left looper in the order (T) to (9) shown below. (Yellow thread
path) (See page 8 for cylinder cover removal)
While holding thread with finger, wrap
thread around tension disk clockwise
till caught in hook and pull thread
down to make certain it is properly
located in between the tension discs.
DU—r
Turn hand wheel toward you
until left looper is at left as far
as it will go and thread the
looper thread hole (8) from left
to right. (Use tweezers provided
in your accessory set).
Turn hand wheel toward you
until the looper is at right as far
as it will go passing the thread
under the throat plate, then
using the tweezers, thread the
looper thread hole (9) from
front to back.
Placé the thread over the top of the right looper and
hold the thread while initially sewing.
See ’Note’ on page 10 for threading the left looper
when thread breaks or when changing the left looper
thread.
11