SINGER 14U236B User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7. How to sew three-thread standard overlook, fiatlock and
wrapped edge overlook
The 3-thread standard ovedock, fiatlock and wrapped edge is sewn with one needle and two loopers.
(1)
Thread the right looper.
Open looper cover. Thread the right looper in the order 0 to (8) as indicated in the figure below,
(orange thread path)
While holding thread with finger, pass it
between the tension discs and pull thread
down
to
make
certain
it
is
properly
located in between the tension discs.
• Use tweezers provided in the accessory set when
threading looper thread hole (8) .
• Draw about 5cm (2 inches) of thread from the
looper thread hole.
(2) Thread the left looper (yellow path) (see page 11)
(3a) Thread the right overedge needle for 3.5mm width (green path) |
Or (3b) Thread the left overedge needle for 5.7mm width (blue path) 1
o
o
(see page 12)
(see page 12)
15