SINGER 6104 - Manual (Page 22)

The zipper foot is also particuiary suitable for
the construction and insertion of corded seams.
CORDED SEAMS
Needle Position:
Stitich Width:
X ; A
i i i i *
♦ Stitich Length: To suit fabric
♦ General Purpose Needle Plate
♦ Zipper Foot
Making the Welting
• Adjust zipper foot to the left of the needle
as described on page 19.
♦ Fold a strip of fabric cut on the true bias
over a cord of the desired length, with raw
edges even. Lower zipper foot. Stitch close
to the cord, pulling
gently on
the strip, both
in front and in back of the zipper foot
Stitching Welting into Seam
♦ Adjust zipper foot to the
right
of the needle
so that the bulk of the fabric will fail to the
left. Stitch welting to the right side of a sin­
gle seam edge: guide the edge of the foot
next to the cord but not too close.
Place the attached, welting over the second
seam edge, and pin or baste together. Place
the work under the foot with the first stitch­
ing on top so that you can use it a guide.
Stitch, this time, with the foot as close as
possible to the cord.
m
2C