SINGER 6104 - Manual (Page 39)

REMOVfHG FACE PLATE PEPLACiNG SUDE PLATE
Loosen screw A (do not remove).
Loosen face plate screw B then remove
face píate by drawing it toward you. Re­
place face plate by sliding top edge of
pfate under edge of arm top cover. Tighten
screws B artd A.
Place slide plate in slide way with the front
edge close to, but riot covering, the retain­
ing spring C. With a small screwdriver, lift
each end of the spring into each of the side
grooves on the under ^de of the slide plate.
Draw the slide plate gently
toward you to
fully engage the spring. Close slide plate.
CHANGING THE UGHT BULB
CAUTION: Before changing light bulb make
sure you have disconnected power fine plug
from socket outlet.
Removing Buib
CAUTION: This machine is designed to use
a 15 watt maximum bayonet base bulb onl^.
R^Iacing Bulb
• Remove face plate.
• Do not attempt to unscrew the buib.
• Press it up into the socket and at iHie
same time turn bulb over in direction
shown to unlock the buib pin and guide
out of socket.
Press new buib into socket,
pins entering slot of socket
with buib
Turn it over in direction shown to lock
bulb in position.
Replace face plate.
37