Four-step buttonhotlng (cont’d.), Changing stitch density – SINGER 6104 User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FOUR-STEP BUTTONHOtlNG (Cont’d.)
Step 3: Sar Tack
Raise the needle above the fabric.
Turn buttonhole dial
ciockwim
to step
3. Take at least four stitches ending
at point D.
Raise the needle above the fabric.
Turn buttonhole dial
clockwise
to 'step
4. Stitch until the side stitching meets
the bar tack at point E.
CHANGING STITCH DENSITY
Stitch density on left and right sides of the buttonhole may be balanced by using the
stitch balance dial. Use the stitch balance dial to obtain similar stitch appearance on
either side of the buttonhole.
To change the density on either side of the buttonhole follow the procedure below.
Return the balance dial to its neutral position after buttonhole sewing is completed.
!F
THEN 00 THIS
RESULT
Stitches on the
right
Side are
too far apart
Similar stitch
appearance on
either Side of
the buttonhole
THHN DO THIS
RESULT
Stitches on the
feft
side are
toe far apart
Similar ststch
appearance on
either side of
the buttonhole
33