Operating the machine, Connecting the machine, Running the machine – SINGER 7011 User Manual

Page 12: Choosing and changing needies, Manejo de la máquina, Conexión de la máquina, Accionamiento de la máquina, Selección y cambio de agujas, Choosing and changing needles

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Operating the machine

Connecting the machine

Push plug (1) into the receptacle (2) at the
right end of the machine. Then connect plug
(3) to your socket outlet.

Running the machine

To turn on machine and sewing light, press

upper portion of power switch (4). To turn

off machine and light, press lower portion “O”
of power switch.

To run the machine and contol speed, press
the foot control (5) with your foot. The harder
you press, the faster the machine will sew.

To stop machine, remove foot from control.

Note:

Do not operate machine without fabric

under the presser foot as this may damage

the feed and the presser foot.

Choosing and changing

needies

Important:

For best results from your sewing

machine, use only SINGER* needles. Check

the needle package, and the Fabric, Thread

and Needle Table on page 16 for the correct

needle and fabric combination.^

• Raise needle to its highest position.

Loosen needle clamp screw and remove

needle.

• With flat side of needle to the back, insert

new needle up into clamp as far as it will

go.

• Tighten needle clamp screw securely.

Manejo de la máquina

Conexión de la máquina

Inserte el enchufe (1) en el receptáculo (2)
colocado a la derecha de la máquina. Luego

conecte la clavija (3) en la toma de corriente.

Accionamiento de la

máquina

Para poner la máquina en marcha y encender
la luz, presionar sobre la parte superior del
interruptor (4). Para apagarla presionar la
parte inferior (O) de dicho interruptor.

Para accionar la máquina y controlar la

velocidad, presionar con el pie el controlador
de velocidad (5). A mayor presión, mayor
velocidad de costura. Para parar la máquina,
quite el pie del controlador.

Nota:

No accionar la máquina sin tejido

debajo del prénsatelas ya que puede dañarse
el arrastre y el prénsatelas.

Selección y cambio de
agujas

Importante:

Para los mejores resultados de

su máquina de coser, utilice sólo agujas

SINGER. Revise él paquete de agujas y la

tabla de tejidos, hilos y agujas de la página

17

, para la combinación correcta de

aguja y tejido.

• Eleve la aguja a su posición más alta.

• Afloje el tornillo y saque la aguja.

• Con la parte plana de la aguja mirando

hacía atrás, inserte la nueva aguja hasta

llegar a su tope.

• Ajuste el tornillo fuertemente.

10

Advertising
This manual is related to the following products: