Step d, Balancing the buttonhole, Tiempo d – SINGER 7011 User Manual

Page 58: Niveiación de ojaies, Stepc, Tiempo c

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

StepC

• Raise needle out of fabric.

• Turn buttonhole dial to the buttonhole symbol

(C)

for the third step.

• Stitch up to point (5).

Step D

Raise needle out of fabric.

Turn buttonhole dial to the buttonhole symbol

(D) for the fourth step.

Make at least four stitches, ending at point

(

6

).

Raise presser foot and remove garment

from machine. Clip thread ends.

Carefully cut buttonhole opening with a
seam ripper or small, sharp scissors.

Balancing the buttonhole

On some kinds of fabrics, there may be a
difference in the density of the stitches on

the right or the left side of the buttonhole.
This is easily adjusted by turning the balance

knob (

1

), in the center of the stitch length dial

to balance the density of the stitching. A very

slight turn of the dial will produce a noticeable
change.

• If the stitches on the right side of the

buttonhole (I) are too open, turn the
balance dial slightly to the right, until the
density of the stitches increases.

If the stitches on the left side of the

buttonhole (II) are too open, turn the
balance slightly to the left, until the density
of the stitches increases.

After the buttonhole has been made and the

balance has been altered, return the balance
dial back to its neutral position after ail the
buttonholes on the garment have been sewn.

Tiempo C

• Saque la aguja del tejido.

• Gire el mando de ojales hacia el símbolo (C)

para realizar el tercer tiempo.

• Cosa hasta el punto (5).

Tiempo D

• Saque la aguja del tejido.

• Gire el mando de ojales hacia el símbolo (D)

para realizar el cuarto tiempo.

• De un mínimo de cuatro puntadas, termi­

nando en el punto (

6

).

• Levante el prénsatelas y quite la prenda

de la máquina.

• Corte los extremos de los hilos.

• Corte el ojal con cuidado, abriéndolo con

un

descosedor

o

con

unas

tijeras

pequeñas y de punta aguda.

Niveiación de ojaies

En algunos tipos de tejidos, puede produ­
cirse una diferencia en la densidad de los
puntos bien en el lado derecho o en el
izquierdo del ojal. Esta diferencia se ajusta

fácilmente girando el botón (

1

) situado en el

centro del dial de longitud del punto, para
nivelar la densidad del punto. Un giro muy
ligero del botón, producirá un cambio
notable.

• Si los puntos del lado derecho del ojal (I)

están demasiado abiertos, gire el botón

ligeramente hacia la derecha, hasta que

aumente la densidad de los puntos.

• Si los puntos del lado izquierdo del ojal

(II) están demasiado abiertos, gire el

nivelador ligeramente hacia la izquierda,

hasta que la densidad de ios puntos
aumente.

Después de haber realizado el ojal y de haber

alterado el nivelador, gire el botón nivelador
a su posición neutra, después de haber

completado todos los ojales de la prenda.

56

Advertising
This manual is related to the following products: