Rolled hemming throat plate, Ordinary overedge throat plate, Be ~ c : i – SINGER 14U32A Ultralock User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(Throat plate available at additional cost)
1. Fabric, needle and thread
Fabric; Light to medium weight (See page 17)
• Rolled hemming is done by rolling the fabric and overedging (seam width 1.5mm), and is not
suited for heavy or stiff fabrics.
Needle: Singer Cat. No. 2054 (#10), #14.
Thread: A variety of thread combinations can be used for rolled hemming.
2. How to exchange throat plate
A throat plate for rolled hem stitching is available
at additional cost. By exchanging the ordinary
overedge throat plate on the machine with a
rolled hemming throat plate by the following
procedure, the machine can be used for rolled hem
stitching.
o
o
Rolled hemming
throat plate
nr
o
Ordinary overedge
throat plate
1. First of all, always disconnect the power line plug from
the receptacle.
2. Turn the hand wheel towards you until the needle is at
its highest point.
3. Lift the Presser foot.
4. Remove the cylinder cover, (see page 4).
5. Unscrew the throat plate screw (1) and remove the
throat plate.
6. Install the ordinary overedge throat plate and replace
the screw (1).
7. Replace the cylinder cover (See paged).
be
~
c : I ' -
'
11