Sewing, Free arm seeving ftyblar work, Free arm sewing (tublar work) – SINGER 14U32A Ultralock User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1. Stitch length adjustment (See page 10)
For rolled hemming, set the feed regulator dial to “2” or “F” and a fine seam can be obtained.
2. Sewing
• See page 8, “4. Chain off and test sewing”.
• For rolled hemming, if a slight tension is applied to the material in the sewing direction, a finer seam
finish can be obtained.
• At the start of sewing, slightly pull the end of the chain off so it will not be entangled in the stitch.
• The overedge stitch width for rolled hemming is approximately 1.5mm and cannot be adjusted,
Inthis case, note that the fabric cut width is 3.5mm (adjusted at shipment).
4. How to sew and cautions
8. Free arm seeving fTyblar work!
This is a free arm machine and is suited for tubular
work.
This is especially convenient for finishing hard-to-
reach areas such as arm holes and overcasting
cuffs.
Slip tubular work onto the free arm and sew.
Use margin lines on looper cover.
Thick line on extreme right is 5/8 inch from center
of needle.
13