SINGER 14T970C User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
While holding thread with fingers, pass it between the
tension discs and puli thread down to make certain it is
properly located in between the tension discs 3.
Continue to thread points 4-8.
Note: Slip thread into the middle slot of the thread
guide 5 and into the slot of take-up lever cover 6
Then continue by slipping thread into the middie
slot of the thread guides 7 and 8.
Before threading eye of needie, make sure thread is
in front of thread guide iocated on the bottom of the
needle clamp for Cover stitch and for Chain stitch.
Thread the eye of the right needie 9.
Note: Use of tweezers in the accessory case wiil
make needle eye threading easy.
Draw about 10cm (4 inches) of thread through
needle eye towards the rear of the machine.
Place the thread to the back under the presser foot.
22