Controls at a glance, Electronic clock and oven control (select models), Cancel pad – Maytag MER4530 User Manual
Page 6: And ▼ pads, Bake pad, Broil pad, Setting the clock, Setting the timer, Additional information, Controls at a glance -6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Controls at a Glance......................
Electronic Clock and Oven Control (select models)
NOTE: The display will flash when the appliance is first connected to power or if power is interrupted. The display
will stop flashing once the time-of-day clock has been set. The BAKE, BROIL and TIMER indicators light when the
function pad is pressed.
Press this pad to cancel all operations except the clock and
▲ and ▼ Pads
Press and tap, or press and hold, these pads to enter the de
sired time, temperature, or to select HI or LO broil.
Use for baking or roasting.
1. Press BAKE pad.
2. Press A or ▼ pad to set the oven temperature.
See page 9 for additional information.
Use for top browning and broiling.
1. Press BROIL pad.
2. Press A or
pad for HI or LO broil.
See page 12 for additional information.
Setting the Clock
1. If the display is flashing, press the CLOCK pad to stop the
flashing, then press the CLOCK pad again.
• If the colon is not flashing, press the CLOCK pad.
• The clock time cannot be set if the control is programmed
for a bake, broil or timing operation.
2. Set the correct time of day using the
and ▼ pads. If the
pad is not pressed within 30 seconds, the program will
cancel. Press the CLOCK pad and begin again.
Setting the Timer
The timer can be set from one minute (:01) up to 9 hours
and 50 minutes (9:50). Time will be displayed in minutes
and not in seconds.
THE TIMER DOES NOT CONTROL
• :00 and the TIMER indicator light will appear in the
display. The colon will flash.
2. Press the
pad until the desired time is displayed.
• The timer will begin as soon as the time is set.
• The flashing colon indicates that a timing operation
is in progress. The colon will not flash if the time of
day or oven temperature is displayed.
• The timer countdown will be displayed unless an
other function is programmed after setting the timer.
• A single beep signals the end of the operation.
“END” will appear in the display. If the time of day
or oven temperature is displayed “END” will not
• A short beep will sound every 30 seconds for five
minutes to remind you that the operation has completed.
If desired, press the
pad and the time of day
will reappear in the display during a timing operation.
To cancel the timer operation:
Press and hold the
pad for three seconds.
A beep will sound each time a function pad is pressed.
There is no beep for the
If a fault code (example: F2) is displayed and beeps
sound, press the CANCEL pad. If the fault code contin
ues, see page 17.