Threading bobbin case – SINGER W910 User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

THREADING BOBBIN CASE

. Hold bobbin case be­

tween thumb and fore­
finger of left hand, so
that the slot in the edge

of the bobbin case is on
top.

Take

the

bobbin

between thumb and fore­
finger of right hand so
that the thread on top
leads from left to right
Insert bobbin into bob­

bin case, pull the thread
into

the

slot

of

the

bobbin case and draw it

under tension spring and

into

the

fork-shaped

opening of the spring.

I

I

PLACING BOBBIN CASE IN SHUTTLE

Raise needle bar to its highest position, and slide plate

forward. Hold the bobbin case latch (D) between the
thumb and forefinger of the left hand, with at least three
inches of thread running from the top of the bobbin

case. Insert and center the bobbin case on the stud of
the shuttle body (C). Be sure the bobbin case finger (E)
is opposite the shuttle race notch (A). Press the bobbin

case (B) into the shuttle as far as possible until the latch
catches on the center post of the shuttle. Then release
the bobbin case latch (D). Press the bobbin case again

after the latch has been released to make sure the bobbin
case is locked securely in place. Close the slide plate.

Advertising