I sectiow – SINGER W910 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PREPARING TO SEW
Have take-up lever at highest position before starting to sew. Pinning may be used
as a time saver instead of hand basting. It is possible to sew over pins when placed at
right angles to the edge of fabric with the pin head at the raw edge, but for best
recommended that the pins be removed as you approach the presser foot
bewing over pins can result in damaged needles.
Place material and threads under presser foot and lower the presser foot. Lower the
needle by turning hand wheel by hand to check if the needle will pierce the stitching
sew^ You are now ready to begin sewing. Press the speed control
If nro!!, ^ machine running is regulated by increasing or decreasing the amount
of pressure exerted on the control. Never run machine without material under
|Ji Cobv^r TOOT.
The scale is etched with every 1/8 inch distance measured from the center of needle
plate. Let the edge of fabric follow the line selected for the seam, and let your eyes
follow the etched line you selected for the seam, not the needle, during sewing To
help you guide the fabric, place cloth guide attachment securing it by the extra
bedplate. Cloth guide and extra thumb screw are
included m your accessory box.
^ v aic
°n°d caisLTt to break
material as this may deflect the needle
Lift the presser foot, turn the
fabric, then lower the presser foot and continue sewing.