C) (d) (e), B) (c) (d) (e) – SINGER W910 User Manual

Page 39

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

CLEANING AND OILING
THE SHUTTLE AREA

The stitch forming mechanism occasional­
ly becomes clogged with loose threads

and lint. This will interfere with the
efficient

operation

of

the

machine.

Cleaning and removal of the lint will

safeguard the performance.
To remove the shuttle assembly, proceed
as follows:

1. Turn hand wheel until the needle

reaches its highest position. Tilt head

back on its hinges.

Remove bobbin case (A).

Turn the two shuttle race cover clamps
(f| outward and remove the shuttle

race cover (C) and the shuttle body
(E) and the lint cleaner (D).

4. Clean the shuttle race, the shuttle, and

shuttle race cover by removing all
threads, lint, etc.

2

.

3.

3.

proceed as follows to replace the shut-

race (F)

When the cleaning has been completed
tie assembly:

1. Turn hand wheel until the needle reaches its highest position.

2. Place lint cleaner (D) to shuttle driver and shuttle body (E)

against shuttle driver and adjust into position.

Replace shuttle race cover (C), fitting pin at lower edge into notch, and lock

into position with shuttle race cover clamps, (f|, making certain the clamps have
been snapped securely Into position.
Put bobbin (B) into bobbin case (A).

:

a

)

(B)

(C)

(D)

(E)

39

Advertising