How to connect the machine to the power supply, How to use the speed controller, How to replace the sewing light bulb – SINGER W1911 Quilter's Friend User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HOW TO CONNECT THE MACHINE TO THE POWER SUPPLY
1. Push the machine plug into the machine.
2. Plug the machine to the power supply.
Note- * Before plugging in the machine, ensure that the voltage and
number of cycles indicated, is conformed to your electrical
power supply.
HOW TO USE THE SPEED CONTROLLER
Sewing speed can be varied by the foot control. The harder you press
on the foot control, the faster the machine runs.
Note: * By releasing the foot control, the machine stops running
automatically.
• Before using the machine, practice controlling the speed with
out threading.
HOW TO REPLACE THE SEWING LIGHT BULB
Before replacing a bulb, disconnect the machine from the power
supply.
To replace the sewing light bulb, use the bulb holder which you
may find in the accessory storage.
Push the holder from bottom until the lug over the bulb and twist
the holder together with bulb counter-clockwise, until the bulb
is taken out.
To replace the new bulb, twist the holder together with bulb
clockwise.