Darning plate – SINGER W1911 Quilter's Friend User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SEWING EMBROIDERY
Presser foot.........................
Pattern selector.................. ................(Cplor
zig zag
Place the fabric in embroidery hoop. (Not included with the
machine.) Place darning plate over needle plate (see below).
Lower the presser foot lifter. Hold the embroidery hoop firmly with
your hand.
While sewing the desired pattern, move the embroidery hoop
slowly and do not allow your fingers to get near the needle.
*Set the needle thread tension a little looser so that the bobbin
thread is not pulled through to the right side of fabric.
(see page 15).
*lt is recommended to mark the required embroidery pattern
on the right side of the fabric with a pencil or tailor’s chalk.
DARNING PLATE
There are a few times when you want to control the feeding of
the fabric yourself. Raise needle to its highest position and
raise presser foot. Place darning plate over needle plate
aligning- two pins of darning plate with holes of needle plate.
You may then determine the movement of the fabric yourself.
See above for embroidery.
31