Threading the bobbin case – SINGER W1911 Quilter's Friend User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
THREADING THE BOBBIN CASE
Hold the bobbin between the thumb and forefinger of your right
hand and pull off about 15 cm (6 inches) of thread.
1. Hold the bobbin case in your left hand as shown and place the
filled bobbin into the bobbin case. Fig.1
2. Pull the thread into the slot in the edge of the bobbin case. Fig.2
3. Now pull the thread under the tension spring and into the thread
eyelet. Fig.3
To insert the bobbin case and bobbin..............
Ensure that about 15 cm (6 inches) of thread extends
out of bobbin case. Hold the bobbin case so that long
finger on the case points up. Open the latch of bobbin
case. Slip the bobbin case over the center pin of hook
and press in place until long finger of the bobbin case
enters notch. Release latch and press down.