Winding the bobbin – SINGER W1911 Quilter's Friend User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
WINDING THE BOBBIN
1. To keep the needle from moving up and
down while winding a bobbin, release
the clutch by turning the outer hand
wheel toward you while holding the
inner hand wheel firmly to keep it from
turning. Fig.1
2. Draw thead from spool through bobbin
winder tension disc as shown. Fig.2
3. Pull end of thread through hole in bobbin
as shown.
4. Place bobbin onto bobbin winder shaft
with end of thread coming from the top
of the bobbin. Push bobbin winder shaft
to the right until it clicks. Holding onto
end of thread, start machine. When
bobbin is slightly filled, snip off end of
thread.
5. Wind thread until winder stops. Remove
bobbin. Clip thread.
6. Tighten outer hand wheel.
16^