U“r*efx i rilxe/\oiimvi (fig. 6) – SINGER W173 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
U“r*Efx I rilxE/\OIIMvi (Fig. 6)
1 . Place spool of thread on left hand spool pin.
2. Lead thread through upper thread guides (A),
3. down and around tension discs (B) from right
to left,
4. into check spring (C),
5. continue to pull on thread until it hooks over
hook (D),
6. up into take up (E) from right to left,
7. down into thread guide (F),
8. through the needle bar thread guide (Q) ; and,
9. into needle from left to right. Pull three or
four inches of thread through needle.
Hold
the
end
of
upper
thread
loosely
and
turn
wheel toward you until the needle goes all the way
down and comes back up. A loop (Fig. 7) will be
formed over the upper thread which then can be
pulled out straight. Place both thread ends under
the presser foot and draw toward the back of the
machine, leaving both threads three or four inches
long.
Fig. 7