Binder – SINGER W173 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
28
BINDER
This
attachment
folds
bias
binding
and
applies
it
to the edge of material in one operation. Slots on
scroll of the binder are for corresponding widths of
commercial folded bias binding. The open mouth of
binder
scroll
is
used
for
unfolded
bias
strips
cut
15/16 inch wide.
FOLDED BINDING (Fig. 37)
Cut a point on folded binding, insert in appropriate
slot. Draw through slot and under binder with strong
pin. Test stitching to be sure it is on the edge.
Adjust sliding binder to right or left.
TWO-TONE BINDING (Fig. 38)
Two bindings can be sewn on fabric edge also in
one operation. When two are used, always skip one
size
between
widths,
inserting
each
in
correct
size
slot.
HAND-CUT BIAS BINDING (Fig. 39)
Cut 15/16 inch bias binding fold in half for a couple
of
inches.
Cut
binding
diagonally
toward
end,
al
most to fold. Slip fold into center of binder. Draw
back until cut opens and binding encircles open end
of scroll. Test stitching to be sure it is on the edge.
Adjust if necessary.
Fig. 37
Fig. 38
#
c
c
6.
e
c
«
c
c
C:
C
C
C
€
€
e
e-