Placing bobbin case – SINGER W173 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
12
PLACING BOBBIN CASE
Fig. 12
Raise needle bar to highest position, and lift hinged
cover plate. (See 12, Fig. 1) Hold the bobbin case
latch (D, Fig. 12), between the thumb and forefinger
of the left hand, with at least three inches of thread
running from the top of the bobbin case to the right.
Insert and center the bobbin case on the stud of the
shuttle
body,
(C).
Be
sure
the
bobbin
case
finger
(E)
is
opposite
the
shuttle
race
notch,
(A).
Press
the
bobbin
case
(B)
into
the
shuttle
as
far
as
possible
until
latch
catches
on
the
center
post
of
the
shuttle.
Then
release
the
bobbin
case
latch,
(D). Press bobbin case again after latch has been
released
to
make
sure
the
bobbin
case
is
locked
securely.
Close the cover plate.